The access point must have a physical WPS push button available.
Please check with your device’s user guide for details.
If the WPS push button is not available please use the instructions on the Standard Connection Method tab.
Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol. Most WPS enabled access points use this protocol.
Step 1
Make sure that the printer is turned on.
Step 2
Make sure that the lamp next to this button starts to flash blue and then go to your access point and press the [WPS]button within 2 minutes.
For exact details on starting WPS on your access point, please refer to its user guide.
The (blue) Wi-Fi lamp on the printer will continue flashing while searching, and the power and Wi-Fi lamp will flash when connecting to the access point. Canon Pixma TS3122 Wifi Setup
When the printer has successfully made a connection to your wireless network, the power and Wi-Fi lamp will stop flashing and remain lit.
Network settings confirmation
To confirm that your printer is successfully connected to your wireless network, you can print out the network settings of your printer if you wish:
При частичном использовании материалов портала
гиперссылка (hyperlink) на «Лучший Город — Воронеж» обязательна.
Полное использование материалов возможно только
с разрешения редакции.
Интернет-портал Лучший Город (Best City)
Свидетельство о регистрации ЭЛ № ФС 77 - 79138 от 22.09.2020
Выдано Федеральной службой по надзору в сфере связи, информационных технологий и массовых коммуникаций (Роскомнадзор)
Учредитель — ООО «ВСС»
Главный редактор — Куранов Ю.Г.
E-mail: sales@best-city.ru
Телефон: +7 (903) 798-68-89
